Guest
Show Posts
1
General Mach Discussion / Changing from plasma to mill profile
« on: January 11, 2021, 04:42:08 PM »
Hello,
I was using the plasma profile and it worked fine.
Now I would like to use the mill profile with the same settings and hardware.
The problem I encountered is that the axes are not moving the right distances, they are wrong by a factor of 1000?
I tried to play around with the motor config but no changes to be noticed.
With the cursor buttons I may move the axes normally, by the measures shown are completely wrong.
Does anyone have an idea how to solve this?
Thank you
Serge
I was using the plasma profile and it worked fine.
Now I would like to use the mill profile with the same settings and hardware.
The problem I encountered is that the axes are not moving the right distances, they are wrong by a factor of 1000?
I tried to play around with the motor config but no changes to be noticed.
With the cursor buttons I may move the axes normally, by the measures shown are completely wrong.
Does anyone have an idea how to solve this?
Thank you
Serge