Hello Guest it is March 28, 2024, 03:22:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - brightnight

Pages: 1
1
General Mach Discussion / Mach 3 Cycle Start Button Won't Work
« on: December 29, 2020, 03:23:53 PM »
First time setting Mach3 mill up for a mill I'm building. Initially the RESET button kept flashing and wouldn't stay green so I disabled my E-Stop button (which I will connect later). Now my RESET button stays green when I click it but when I load and try to click on the CYCLE START button it's all grayed out and won't start. I don't have anything connected to my controller board, I just want to make sure it's talking to the computer correctly and hear the relay click on/off when I hit run. Is it possible I need to configure more inputs or is there a dialog box somewhere that tells me what is holding it up from running? In the YouTube videos I watched from a clean install it just worked but not sure what they had connected.Thanks!

Pages: 1