Topics

1

General Mach Discussion / MPG controler and mach3

« on: March 22, 2021, 04:29:55 PM »

Hey I am considering buying an MPG controller Machifit Wireless Electronic CNC Handwheel. I am using win XP with uc100 motion controller and Mach3. if anyone has experience with this, will it work? I am a bit suspicious because an xbox 360 contrler does not work.

2

General Mach Discussion / E stop

« on: February 06, 2021, 05:58:10 AM »

During the program I often get an e stop emergency. Sometimes none and sometimes several times in the same program. What could be the cause of this

3

General Mach Discussion / zero setting changes after running program

« on: February 06, 2021, 05:54:18 AM »

My cnc mill works under win xp. I am using mach3 the latest version. I want to run a program on my mill several times in succession. The problem is that I have to set the zero setting every time again.
When the program is done the spindle goes to the zero position, but then it changes the coordinates of X, Y and Z. What is the problem here.