Hello Guest it is January 23, 2022, 01:52:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Bruce Hodgkins

Pages: 1
1
General Mach Discussion / 6040 cncest
« on: September 25, 2021, 08:19:43 PM »
Hi I am currently running mach3 on my mill. Do the chinese machines work successfully using Mach 4

2
General Mach Discussion / mach connection to rnr motion board
« on: May 17, 2021, 06:38:52 PM »
Hi power was cut several times to the rnr controller.  Port 1 disconnected during this issue now Mach 3 refuses to talk to the controller other than the spindle. Any ideas??
Cheers Bruce

3
General Mach Discussion / limit switches
« on: January 22, 2021, 09:04:01 PM »
Hi I have set up limit switches  in NO configuration on a 6040 chinese router. I cannot get Mach 3 to recognise the switches. I have tried many different settings in ports and pins without success. Machine has a Bitsensor bob HELP

4
General Mach Discussion / limit switches
« on: January 22, 2021, 07:18:27 PM »
Hi I have set up nc limit switches to a 6040 cnc with a bitsensor breakout board. Cannot get Mach 3 to recognise the switches. I have been through ports and pins a dozen times makes no difference. Connections on Bitsensor board are common to DCM and signal to in2. Hope somebody can help.

5
General Mach Discussion / Spindle won't run
« on: November 27, 2020, 07:59:32 PM »
 >:(  Have bought 6040est I have set it up and ran roadrunner test g code now the spindle won't run through the pc any thoughts?  Bruce

6
Third party software and hardware support forums. / 6040 est usb help
« on: October 25, 2020, 05:27:25 PM »
Am a newb to cnc.  computer that I have is misbehaving no wifi connectivity so need a new one. Any ideas on my requirements would be appreciated

Pages: 1