Hello Guest it is April 25, 2024, 07:19:35 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Zama-shi

Pages: 1
1
FAQs / Homing and Limit Configuration
« on: October 13, 2020, 05:26:04 AM »
I have a Sherline 5410 (metric) milling machine running through a cheap Chinese breakout board by Bitsensor.com model BSMCEO4U-PP.  I have all the axes and pin setup correcting where I can jog back and forth through Mach3.  However; my problem is setting up my homing/limit configuration.  I have looked at many online tutorials and some of them can be a little confusing to a person unifiliar to Mach3.  Dose anyone know the proper setup for homing/limit configuration for a Sherline Mill or should I say does anyone know of a good tutorial step-by-step guide for a newbie to Mach3?

Pages: 1