Hello Guest it is November 30, 2021, 06:14:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Andrei Cristian

Pages: 1
1
General Mach Discussion / Help a newbie
« on: October 10, 2020, 10:39:31 AM »
Hello everybody, i just bought a 6040Z, this wonderful chinese machine comes with mach3, now, this program beats me, hard, i almost hate it, i couldn't find help anywhere else so i decided to make a post here.

My problems are:
the machine homes X and Y before Z, which caused me to brake a almost brand new end mill
the spindle speed max is defaulted to 8000 even though my spindle can do up to 24k

I only hope there's somebody here that can help me, cause i've spent two days already trying to figure it out and all i found was people having trouble setting their limit switches, which i dont (yet) have

Thank you.
Andrei

Pages: 1