Guest
Show Posts
1
General Mach Discussion / Connecting a servo driver
« on: October 10, 2020, 05:24:01 AM »
Hi.
I hope someone can help with servo driver connections.
My cnc lathe has Fagor servo drivers, and closed loop encodes with the service motors.
The servo driver board has 3 connections, each with a + and - leg.
I want to connect this board to my Mach3 driven breakout board, but don't know which connections are for direction and which for step.
The three connections are : command, limit, and enable.
I could assume comand is the step connection, and enable the direction connection.
Would you agree? (Before I break something).
Many thanks
John
I hope someone can help with servo driver connections.
My cnc lathe has Fagor servo drivers, and closed loop encodes with the service motors.
The servo driver board has 3 connections, each with a + and - leg.
I want to connect this board to my Mach3 driven breakout board, but don't know which connections are for direction and which for step.
The three connections are : command, limit, and enable.
I could assume comand is the step connection, and enable the direction connection.
Would you agree? (Before I break something).
Many thanks
John