1
Mach4 General Discussion / Laser won't fire from Ethernet smooth stepper
« on: October 05, 2020, 08:24:48 PM »
Got a diode laser, hooked it up to a breakout board using ess. Set the pwm output to port 1 pin 1.
Confirmed that when I change this pin to "active low" , the laser WILL fire and stay on. Configured everything as directed under laser tab in was plugin using the support page.
Nothing will fire the laser. No g code, not the sample g code they give, nada. The laser screen set fire laser buttons don't work. Can anyone help? Just wanna make simple cuts to start out
Confirmed that when I change this pin to "active low" , the laser WILL fire and stay on. Configured everything as directed under laser tab in was plugin using the support page.
Nothing will fire the laser. No g code, not the sample g code they give, nada. The laser screen set fire laser buttons don't work. Can anyone help? Just wanna make simple cuts to start out