Hello Guest it is August 06, 2020, 09:20:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - bslater

Pages: 1
General Mach Discussion / Mach 3/winxp system crash
« on: September 12, 2007, 06:30:52 PM »

I have installed Mach 3 r2.4 on my laptop, with xp installed as standard PC, 550mhz AMD Processor, 160m ram.  Mach is the only program installed with the license file in the correct location on the system with a new clean install of the xp.

When I start Mach 3 it begins to load, then, the blue screen of death, and the whole computer reboots.  I have tried normal XP install as well and had no luck.

Any suggestions?


Pages: 1