Hello Guest it is December 01, 2021, 02:42:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - spenceanthony21

Pages: 1
1
Hello, I am new to the forum and also to using Mach3. I recently undertook the task of setting up a 3-axis K2 router equipped with servos and new Geckodrives G320X. I am having trouble setting up mach and getting it to communicate with the servos. The drives were previously installed by someone else and I dont know which ports and pins to designate on Mach. Does anyone have a complete rundown or tutorial to set up something like this? I am basically starting from scratch here and dont have a clue as to what to do. Any info would be much appreciated.

Pages: 1