Guest
Show Posts
1
General Mach Discussion / Z-axis changing during job & depth is increasing
« on: July 17, 2021, 04:35:24 AM »
Hello
I have a wood CNC. While I wanna cut a borderline or when I wanna make a 2d model with V-Craving in artcam , the Z axis increasing over time and depth of job is deeper than programmed. For example I set depth on 4mm , in the end depth was increased slowly and reached to 7.734mm.
I don't know where is problem and why it should be work like that. I tried different ways in artcam and changed the model but it's still do wrong job .
Thanks for your guidance 🙏
I have a wood CNC. While I wanna cut a borderline or when I wanna make a 2d model with V-Craving in artcam , the Z axis increasing over time and depth of job is deeper than programmed. For example I set depth on 4mm , in the end depth was increased slowly and reached to 7.734mm.
I don't know where is problem and why it should be work like that. I tried different ways in artcam and changed the model but it's still do wrong job .
Thanks for your guidance 🙏
