Guest
Show Posts
1
Mach4 General Discussion / Mach4 Pokeys57cnc and Consew
« on: August 23, 2020, 10:58:32 AM »
Lathe works 98% up until the gcode calls for a linear feed.
Consew motor runs and is controlled independently of Mach4 through its own controller. Is there some way to override Mach4 into thinking it’s connected to the motor, as I assume it’s not moving because it does not detect any spindle speed?
Consew motor runs and is controlled independently of Mach4 through its own controller. Is there some way to override Mach4 into thinking it’s connected to the motor, as I assume it’s not moving because it does not detect any spindle speed?