Hello Guest it is May 18, 2021, 05:43:18 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - c3l1n

Pages: 1
1
Mach4 General Discussion / Touch sensor mounted at side of spindle.
« on: August 19, 2020, 01:11:07 PM »
Hello,

is it possible to setup somewhere in Mach4 offets of touch sensor? I decided to mount my self made sensor not in spindle but at some offset (to have quick access to measure without changing tool). So what I want is to perform some calculation in TouchOf plugin to substract offsets.

Best regards C3l1n

Pages: 1