Hello Guest it is March 28, 2024, 07:18:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - KDRedSmith

Pages: 1
1
Mach4 General Discussion / 3D touch-probe with large offset to spindel
« on: August 17, 2020, 06:42:33 AM »
Hello all,

I'm new to this forum and hope that you could help me with my problem.
I have converted a manual mill over the last months to cnc. For the controller
I'm using a pokeys57cnc with mach4 hobby.
Now I have the following problem:
I build a retractable 3D touch probe which is permanently mounted to the mill
with a large offset (round about 85mm in x) to the spindle. I can't find a way
to calibrate the touch probe. Is it possible to set the Position of the precision bore to zero
but calibrate at the current position? This way i could zero my spindle und move the
touch-probe to the bore and run the calibration routine.
I hope you could help me with my problem.

Best regards,

KDRedSmith
   

Pages: 1