Hello Guest it is May 18, 2021, 05:40:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - xusmcx

Pages: 1
1
I am new to the forum. I have an issue that just started and I dont know how or where to correct. I have restored from an older backup before the issues but that did not help.

When I press the Goto work zero the cnc does go to work zero but does not release and the cycle time continues to run. I have to manually press stop. If I run a gcode it does the same thing I have to press stop and then start to get the cnc to continue to run the code. Really annoying. If anyone can point me to where I should look I would really appreciate any help.

Thank you

Pages: 1