Hello Guest it is March 28, 2024, 05:52:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - thewillow

Pages: 1
1
General Mach Discussion / designing problem
« on: November 10, 2020, 08:05:14 PM »
Hi All, I've been using the newer version of mach3 (0.18) and I'm looking for a better way of coming up with a foil design. When I'm cutting the foil, I have a problem near the tip of the fin which looks like a design fault (mine). I've tried sweeping instead of lofting but can't quite get the program to respond without a message error. Wondering if anyone has a simpler way of sweeping reliably.

Pages: 1