Guest
Show Posts
1
Mach4 General Discussion / complex probe moves not working
« on: October 20, 2020, 03:44:44 PM »
Hello, I try to get my new 3D touch probe working in Mach4, but I am puzzled with certain not working behavior. While simple probing like edge finding or z-finding works OK more complex moves like finding center of opposite edges do not work. Here the probe should move from the middle past the first edge, dive down and do its probe move.
In my Mach4 it only does the first x/y move behind the first edge and stops. Nothing more until Reset is pressed. Normally it should move down the z-axis to dive in, but it stops in middle of the probing script.
Anybody with an idea what's might going wrong?
I tried different z-settings and even the most recent developer version of Mach 4.2 without any success.
Mike
In my Mach4 it only does the first x/y move behind the first edge and stops. Nothing more until Reset is pressed. Normally it should move down the z-axis to dive in, but it stops in middle of the probing script.
Anybody with an idea what's might going wrong?
I tried different z-settings and even the most recent developer version of Mach 4.2 without any success.
Mike