1
General Mach Discussion / Getting Mach3 on new PC (revisited)
« on: August 01, 2020, 11:30:27 PM »
I did some searching and found this topic 3 years ago but the solutions did not work. I recently purchased Mach3 for my sons home-built WorkBee CNC. All worked great for a few weeks. Now, after running fine for 10 minutes it starts to convulse, jerking along the cutting path.
Lot's of possible causes and I am willing to hear other solutions - guys/gals???
One solution was to try another PC. The reason we bought M3 vs M4 was it we were suppose to be able to install it on more than one PC. When I use the install link from M3/ArtSoft (license@machsupport.com) is stays install limit exceeded.
How can I get this onto a second (and maybe 3rd (laptop) and we try to best configure out CNC shop and set up?
Thanks
Lot's of possible causes and I am willing to hear other solutions - guys/gals???
One solution was to try another PC. The reason we bought M3 vs M4 was it we were suppose to be able to install it on more than one PC. When I use the install link from M3/ArtSoft (license@machsupport.com) is stays install limit exceeded.
How can I get this onto a second (and maybe 3rd (laptop) and we try to best configure out CNC shop and set up?
Thanks