Guest
Show Posts
1
General Mach Discussion / Mach3 Conveyor belt
« on: July 20, 2020, 09:22:33 AM »
Hello Fellow Forum Users,
I'm new to Mach3 and I have a Question, I use the Mach3 Motion Card to move a conveyor belt (X-Axis) and it works perfectly fine, as long as I want it to move to a certain position. Now my Question is, how do I make it stop and execute a macro as soon as it reaches a photoelectric barrier?
Ah and how can I make the G-Code repeat itself? Let's say we want to do more than one piece and don't want to press "Cycle Start" each and every time.
Greetings
LG
I'm new to Mach3 and I have a Question, I use the Mach3 Motion Card to move a conveyor belt (X-Axis) and it works perfectly fine, as long as I want it to move to a certain position. Now my Question is, how do I make it stop and execute a macro as soon as it reaches a photoelectric barrier?
Ah and how can I make the G-Code repeat itself? Let's say we want to do more than one piece and don't want to press "Cycle Start" each and every time.
Greetings
LG