1
Mach4 General Discussion / HOME with absolute encoders
« on: July 07, 2020, 10:12:12 AM »
I am planning on retrofitting a lathe with DMM servo motors with multi-turn absolute encoders. I consider running it with Mach4.
Is it possible to configure Mach4 to HOME with absolute encoders?
I know LinuxCNC can do that with the HOME_ABSOLUTE_ENCODER configuration setting. I am really trying to avoid using LinuxCNC for this machine and run it with a user-friendly controller such as Mach4.
Is it possible to configure Mach4 to HOME with absolute encoders?
I know LinuxCNC can do that with the HOME_ABSOLUTE_ENCODER configuration setting. I am really trying to avoid using LinuxCNC for this machine and run it with a user-friendly controller such as Mach4.