Hello Guest it is October 19, 2019, 11:42:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - oleg

Pages: 1
1
General Mach Discussion / unknown problem with arcs
« on: May 12, 2006, 03:05:18 AM »
 >:( ???
         I have some problem with DXF file.The program dnt eat arcs and breaked circles.It write – “Radius to end of arc differs from radius to start”

How can I solve this problem?

Thank You, Oleg

Pages: 1