Guest
Show Posts
1
Mach4 General Discussion / Mach 4 with PMDX-126 and ESS proximity switches
« on: June 26, 2020, 11:43:22 AM »
I was wondering if anything that has a similar setup mind showing their settings for the machine and ESS for homing switches? I have all the motors and eveything appears to be working but when the machine start to home the Y towards the back (One with Y + and Slave (pin 13) it seems the pin 13 does not stop and will eventually try to run off the machine. I am new to this so I am sure it is something stupid, but just not able to get it going and would love to run a test run finally.
I did purchase this off of someone and they used Mach 3 which I could use, but every XML I download from Avid, does not work or its way worse and nothing works. So if someone had an XML I could try, I can also put Mach 3 back on and see what happens.
I did purchase this off of someone and they used Mach 3 which I could use, but every XML I download from Avid, does not work or its way worse and nothing works. So if someone had an XML I could try, I can also put Mach 3 back on and see what happens.