Hello Guest it is March 28, 2024, 06:20:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - normann

Pages: 1
1
General Mach Discussion / USB to Serial
« on: June 18, 2015, 05:01:51 PM »
My old computer with a 25 pin Serial port crashed.
My "New" pc don`t have this port. Only USB. My breakoutboard has the 25 pin Serial so I bought a adapter USB to 9-pin to 25 pin and hoped this would solve my problem.
I installed the driver, but I can`t get my mill to life.
Can someone guide me through Mach3 settings to set up my New cable?

2
General Mach Discussion / Trouble with setup
« on: September 08, 2007, 06:36:35 AM »
It should be right forward. When I was finished and connected to my PC and started Mach3, nothing happened.
I have my motors on my desk, just want to see them move when I run the “Roadrunner” G-code. I was quite disappointed when I just heard a ”tic” from time to time.
I tried to change the pins for output, but no. Nothing. I have tried to change many variables. Nothing happens.
If ther is some one “out there” with the same package, let me hear from you.
I have to mention that I could not use the power supply that was set up with the package. In Norway we have 230V. I bought two new power supplies. One 24V, 1.9A and one 6V supply (this one can be regulated down to 4.5V and up to 7.5V). When I measure the 24V supply the meter shows 23.5V (is this critical?). In the specs for the breakout board it says 24-40V

Links:
http://www.kelinginc.net/ThreeXCNCPackage2.html

http://www.kelinginc.net/KL-4030Wiring.pdf

http://www.kelinginc.net/KL23H276-28-4B.pdf

I really hope someone can help me.

Best regards
Terje

Pages: 1