1
Mach4 General Discussion / EMCO 6P CNC retrofit - M6 Issue
« on: June 09, 2020, 03:58:17 PM »
Hi everyone,
Just arrived to the Mach community.
About to finish a complete rewamping of a very old emco 6P cnc including mach4 and pokeys57cnc.
I need help to write the M6 code for my ATC 8 station turret. A combination of 4 sensor give a feedback of which position is currently active and used to stop the motor to rotate the turret.
Thanks in advance for help.
Cedric.
Just arrived to the Mach community.
About to finish a complete rewamping of a very old emco 6P cnc including mach4 and pokeys57cnc.
I need help to write the M6 code for my ATC 8 station turret. A combination of 4 sensor give a feedback of which position is currently active and used to stop the motor to rotate the turret.
Thanks in advance for help.
Cedric.