Hello Guest it is May 07, 2021, 01:26:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Olli-CNC

Pages: 1
Mach4 General Discussion / This function is unlicensed?!
« on: October 06, 2020, 08:02:46 AM »
"This function is unlicensed" is an error that Mach4 Hobby tells me if I use a program that was made by the Fanuc postprocessor over Fusion 360.
There are pararmeters for probing edges in it.

What should this bull*********?!

Mach4 Hobby has integrated Probing, why we can't use it in a program? Because of this small thing we have to buy the industrial version?

Is there a solution for this?


Mach4 General Discussion / Counts per Unit Question
« on: June 05, 2020, 07:22:19 AM »
Hello Folks,
I'm optimising my CNC-Router and I have to change the counts per unit. I use the metric system (I'm from Germany  ;))
My question, can I use decimal numbers like this '999.5' ?



Pages: 1