Hello Guest it is May 09, 2021, 11:57:22 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - coreyhagan1

Pages: 1
Mach4 General Discussion / No motion controller..
« on: May 27, 2020, 02:42:46 PM »
I was using my machine the other day and mach 4 crashed, so i restarted the program. Now every time i open the program it shows a error message asking me to choose my motion device. it does not allow me to choose a motion device because there isnt one present. i use the hiCon motion controller and the calt TM1474 encoder as well. any one else ever had this issue or have a idea how to figure it out.

Pages: 1