1
General Mach Discussion / Mach3 Jog around the Block
« on: May 13, 2020, 09:53:51 AM »
Hi I'm John (mach3 newbie)
With my other cnc router and control software, If I want to jog 12" from any point, I can enter 12 in a X/Y box and click the arrows and jog around the table 12" at a time. When manually zeroing I can set the step size as needed to move in small increments.
Is there a way to do that in Mach3 short of entering GCode commands?
With my other cnc router and control software, If I want to jog 12" from any point, I can enter 12 in a X/Y box and click the arrows and jog around the table 12" at a time. When manually zeroing I can set the step size as needed to move in small increments.
Is there a way to do that in Mach3 short of entering GCode commands?