Guest
Show Posts
1
General Mach Discussion / Demo version
« on: April 30, 2020, 11:40:49 AM »
Hi every one,
Just joined the forum after downloading the demo as advised before purchasing a licence.
I am a 66 year old from the UK just trying to find a retirement hobby. Building my own cnc router and now ready to get it started!
I have a Mach 3 usb interface board, with 6650 drivers and nemo 23 motors. I cannot seem to communicate with the board, although the usb port sees something as the boards red light is blinking. After investigation i clicked driver test in the Mach program and it is saying "No driver sensed installed". Tried installing Special driver still no good. Might have made an error in downloading the parallel port driver? Running Windows 10 Ver. 1909.
Any ideas where i am going wrong? Many thanks in advance
Mike
Just joined the forum after downloading the demo as advised before purchasing a licence.
I am a 66 year old from the UK just trying to find a retirement hobby. Building my own cnc router and now ready to get it started!
I have a Mach 3 usb interface board, with 6650 drivers and nemo 23 motors. I cannot seem to communicate with the board, although the usb port sees something as the boards red light is blinking. After investigation i clicked driver test in the Mach program and it is saying "No driver sensed installed". Tried installing Special driver still no good. Might have made an error in downloading the parallel port driver? Running Windows 10 Ver. 1909.
Any ideas where i am going wrong? Many thanks in advance
Mike