Guest
Show Posts
1
Mach4 General Discussion / Mach4 Parallel Port Axis Setup
« on: February 10, 2020, 07:46:18 AM »
Hi there,
I'm new to the CNC world and have been trying to setup a machine with mach4. I was able to set it up with mach3 and everything seemed to work fine, so I bought Darwin to try mach4.
The problem I'm having at the moment is that I can't get all axes to run at the same time. I have a direction pin for x as 7, and step pin for y is also 7. For some reason this worked in mach3 but Darwin doesn't seem to like this. Any help is much appreciated.
Thanks,
Aaron
I'm new to the CNC world and have been trying to setup a machine with mach4. I was able to set it up with mach3 and everything seemed to work fine, so I bought Darwin to try mach4.
The problem I'm having at the moment is that I can't get all axes to run at the same time. I have a direction pin for x as 7, and step pin for y is also 7. For some reason this worked in mach3 but Darwin doesn't seem to like this. Any help is much appreciated.
Thanks,
Aaron