Guest
Show Posts
1
General Mach Discussion / Set tool length
« on: May 23, 2006, 04:22:40 PM »
Hi, I have a question for you.
I have a sensor for set a tool length but I don’t know how can use it.
Is it possible make a automatism for use it?
There Is a macro?
Could tell me more about?
Regards
Milko
I have a sensor for set a tool length but I don’t know how can use it.
Is it possible make a automatism for use it?
There Is a macro?
Could tell me more about?
Regards
Milko