Guest
Show Posts
1
General Mach Discussion / X axis not working with code
« on: January 23, 2020, 10:24:07 AM »
Hello,
Im using the Aspire software to create my codes, and for some reason when i start the code the X appears to be moving in mm instead of inches but the Y and Z are moving just fine. It also jogs just fine, but also when I put in G-code for any movement in X it seems to move small increments and displays the coordinates as if it moved an inch when again it only moved about a mm.
Any suggestions?
Im using the Aspire software to create my codes, and for some reason when i start the code the X appears to be moving in mm instead of inches but the Y and Z are moving just fine. It also jogs just fine, but also when I put in G-code for any movement in X it seems to move small increments and displays the coordinates as if it moved an inch when again it only moved about a mm.
Any suggestions?