Topics

1

Mach4 General Discussion / Mach4 Plasma move Z+ after cut

« on: January 20, 2020, 01:26:33 AM »

Hello,


Is there a possibility that the Z axis moves up to a certain value after cutting a contour (eg + 50mm). To be at a sufficient distance from the sheet metal so as not to get caught anywhere. Could you program that into the M5 macro and if so how?


Thank you so much

2

Mach4 General Discussion / Mach4 + Plasma MACRO ALARM Help

« on: January 17, 2020, 03:46:55 AM »

Hello,


Since yesterday I have had the following problem with my Mach4 and Plasma. The machine moves to the starting point of the new cutting contour. The plasma torch then ignites. The machine now moves in normal white, but it stops and this error message appears after 4 seconds.

Best regards Alex