Topics

1

General Mach Discussion / Waterjet/lookahead/accelerate-slowdown

« on: February 05, 2007, 03:28:35 PM »

How and where do I apply settings to make the feedrate slow down before a curve and speed back up after it? Can I adjust these settings?
Peter 

2

General Mach Discussion / Motor Speed Wizard in M3

« on: April 23, 2006, 02:10:30 PM »

I cant find it again.
Iplayed with it and was impressed but now I can find it.
Said: How far do you want the motor to move,
How far DID it move,
then it set the ratios.
Now I cant find it again 
Peter