Hello Guest it is March 28, 2024, 03:05:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - randybradley

Pages: 1
1
Mach4 General Discussion / mach4 will not hold zero
« on: May 29, 2021, 04:28:30 PM »
I run an operation (using BobCad). Zero in "X" moves .100 when I put my next part in. 

2
Mach4 General Discussion / Y axis is jumping
« on: March 27, 2021, 04:02:09 PM »
Hello All,
I run a program and it goes through the program just fine. I put in another part, Y axis jumped about .125, I keep running the program and it does fine except for the .125 initial jump. I put another part in and Y jumps another .125.
I run the  program from a cad drawing or enter the g code myself, and it does the same thing. When I use jog it is consistent through all parts. Could this be a glitch in the mach4 program?

3
Mach4 General Discussion / mach4 will no hold zero
« on: March 17, 2021, 06:02:53 PM »
I run a program, put in another part to machine. Zero is off by as much as .125.

4
Mach4 Toolbox / not drilling
« on: February 23, 2021, 05:45:19 PM »
Hello All, I have a program that I have used several times and it worked fine.  Part of it is drilling holes, I tried again today, when it gets to where its supposed to drill several holes, it moves along the correct tool path, as it gets to each hole it very briefly stops, hums, doesn't drill hole and moves on. I did mess with the "config. > control > motor and thought I got it back to the original numbers, but it still does the same thing. any suggestions?

5
FAQs / conf. motors
« on: February 16, 2021, 04:47:06 PM »
conf.>control> motor> There are no figures for "Counts per unit", "Velocity", "Acceleration". Also, when I try to type in numbers they are not accepted. What am I missing?
 

6
Mach4 Plugins / Vista Pendant on Mach4
« on: October 23, 2020, 01:00:08 PM »
I have the Vista iMach P2-s Pendant. The directions say: go to config > plugins. I do that and the Pendant does not show up.  Any suggestion
Randy

7
Mach4 Plugins / (No subject)Motion Controller
« on: October 09, 2020, 01:41:04 PM »
I can't find a remote controller (I know there is another name for it) for mach4. Suggestions anyone

8
Mach4 General Discussion / Remote controllers for mach4
« on: July 15, 2020, 10:52:06 AM »
I have mach4 software and a 3 axis router, I'm looking for a Remote controller. Seems everywhere i look it say's mach3, does this mean they are not compatible to use with mach4? If not, please, suggestions on a remote controller for mach4!
Randy

Pages: 1