Hello Guest it is March 28, 2024, 07:47:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Spragnut

Pages: 1
1
Mach4 General Discussion / Homing - Reverse Direction?
« on: December 19, 2019, 11:12:43 AM »
Hi,

I've recently set about doing an overhaul/rewire on an old Pacer Cadet router, mechanically it was fine but the electronics were shocking to say the least.

I've set about re-wiring it and also took the opportunity to upgrade to an ESS and MB3 breakout along with some G201X drives, everything is working as it should but I've hit a wall now I'm trying to get the machine to home correctly.

The Cadet is setup to home bottom right as you look at the machine. On the Mach 3 install that came with the machine, which has now died, when incremented from the home position X was positive and Y negative, this worked fine as Fusion can generate gcode to reflect this.

On the Mach 4 install I either get it to increment correctly or home correctly, if I flip the dir pin I get it to increment positively but then the home direction is wrong.

Is there a simple flip home position button that I'm missing, or will I be better off just moving the limit switches so it homes from bottom left?

Any help would be most appreciated.

Cheers
James

Pages: 1