1
General Mach Discussion / How do you resume after a flame-out?
« on: December 06, 2019, 02:34:42 AM »
I am running a plasma machine. Midway through the burn the plasma stopped firing and continued on the G-Code path. I stopped the machine and reset the Plasma machine. I have identified roughly what line of code it encountered the error and would like to restart the program a few lines of code before.
I am new to Mach3 and can't seem to figure out what buttons to push to allow me to do that. I have tried to enter the code line number and tell it to begin from there but it just scrolled down to line 9 and stops.
If i could be pointed in the right direction or told where in the manual this is discussed I would be greatful.
Kelly
I am new to Mach3 and can't seem to figure out what buttons to push to allow me to do that. I have tried to enter the code line number and tell it to begin from there but it just scrolled down to line 9 and stops.
If i could be pointed in the right direction or told where in the manual this is discussed I would be greatful.
Kelly