1
General Mach Discussion / Several problems after updating form a much older version
« on: August 27, 2007, 07:40:35 PM »
I loaded updates for Mach III mill and now I’m having these problems:
1) When the direction of cutting in the x-axis reverses the feed rate briefly slows then picks back up to normal which leaves burn marks in my wood.
2) The jog speed has slowed down to half or less than before even though it is set at 100%
3) The screen size has been reduced like when you change the screen resolution to a higher setting.
Thanking you in advance.
Brian
1) When the direction of cutting in the x-axis reverses the feed rate briefly slows then picks back up to normal which leaves burn marks in my wood.
2) The jog speed has slowed down to half or less than before even though it is set at 100%
3) The screen size has been reduced like when you change the screen resolution to a higher setting.
Thanking you in advance.
Brian