1
General Mach Discussion / Mach3-The machine stop in execut program
« on: October 28, 2019, 08:27:22 AM »
hi everyone,
I'm new in this site, and I need help.
I have a machine controlled by mach3.
The operative system is Win7, and used a USB card interface.
(link)
https://www.google.com/imgres?imgurl=https%3A%2F%2Fwww.buildyourcnc.com%2Fimages%2FIMG_20181228_145312__01-800.jpg&imgrefurl=https%3A%2F%2Fbuildyourcnc.com%2Fitem%2FelectronicsAndMotors-electronic-component-breakout-Mach3-USB-Board&docid=2HKAsEYfKSQ2-M&tbnid=b_h_yNX5n8dbDM%3A&vet=10ahUKEwjklvjc9r7lAhVtIrkGHW4ZC9gQMwhGKAIwAg..i&w=800&h=654&client=firefox-b-d&bih=654&biw=1366&q=usb%20mach3&ved=0ahUKEwjklvjc9r7lAhVtIrkGHW4ZC9gQMwhGKAIwAg&iact=mrc&uact=8
I have problem when I run a program, in a "program run mode" in mach3.
The machine normal start to run, but then y stop at 25 second(proximately).
I read in many sites that this problems can be the watch dog(in "general config"), so y see this configiguration, and it is not activated.
Can be any know something about that?
Thanks very much
Ariel
I'm new in this site, and I need help.
I have a machine controlled by mach3.
The operative system is Win7, and used a USB card interface.
(link)
https://www.google.com/imgres?imgurl=https%3A%2F%2Fwww.buildyourcnc.com%2Fimages%2FIMG_20181228_145312__01-800.jpg&imgrefurl=https%3A%2F%2Fbuildyourcnc.com%2Fitem%2FelectronicsAndMotors-electronic-component-breakout-Mach3-USB-Board&docid=2HKAsEYfKSQ2-M&tbnid=b_h_yNX5n8dbDM%3A&vet=10ahUKEwjklvjc9r7lAhVtIrkGHW4ZC9gQMwhGKAIwAg..i&w=800&h=654&client=firefox-b-d&bih=654&biw=1366&q=usb%20mach3&ved=0ahUKEwjklvjc9r7lAhVtIrkGHW4ZC9gQMwhGKAIwAg&iact=mrc&uact=8
I have problem when I run a program, in a "program run mode" in mach3.
The machine normal start to run, but then y stop at 25 second(proximately).
I read in many sites that this problems can be the watch dog(in "general config"), so y see this configiguration, and it is not activated.
Can be any know something about that?
Thanks very much
Ariel