Hello Guest it is March 28, 2024, 11:12:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cajgood

Pages: 1
1
Mach4 General Discussion / 4th and 5th axis add on
« on: October 21, 2019, 02:59:33 PM »
Hello Friends,

We have a MachMotion 3 axis control package we put on a surface grinder.
For the most part it does what we need.
The package we received was already set up so not a lot of configuring needed.
Well my boss got a cheap 4th and 5th axis fixture from Ebay that he want's me to hook up.
It has a table that rotates on 1 axis and a chuck the rotates on the other.
It came with 57HS76-3004A08-D25 stepper motors with 4 wires each.
Do I need to get drives for these or can the Apollo III control without drives?

Any help would be appreciated.
Thanks.
Cajgood
Modify message

2
Mach4 Videos / 4th and 5th axis add on
« on: October 21, 2019, 02:48:51 PM »
Hello Friends,

We have a MachMotion 3 axis control package we put on a surface grinder.
For the most part it does what we need.
The package we received was already set up so not a lot of configuring needed.
Well my boss got a cheap 4th and 5th axis fixture from Ebay that he want's me to hook up.
It has a table that rotates on 1 axis and a chuck the rotates on the other.
It came with 57HS76-3004A08-D25 stepper motors with 4 wires each.
Do I need to get drives for these or can the Apollo III control without drives?

Any help would be appreciated.
Thanks.
Cajgood

Pages: 1