1
Mach4 General Discussion / Mach 4 Screen Editor GCode Help
« on: October 09, 2019, 10:58:01 AM »
Please can somebody help out with a screen editor question:
I require a button on a Mach4 screen that moves the Y axis on my router table forward by 10mm, and then once the button is toggled again it should move back 10mm to its original location. I would also like for this to be triggered by an input on my Hicon Integra motion controller if possible?
I would imagine it would require running a line of GCode, but I don't know where to start with the LUA script
Thanks!
I require a button on a Mach4 screen that moves the Y axis on my router table forward by 10mm, and then once the button is toggled again it should move back 10mm to its original location. I would also like for this to be triggered by an input on my Hicon Integra motion controller if possible?
I would imagine it would require running a line of GCode, but I don't know where to start with the LUA script
Thanks!