Topics

1

General Mach Discussion / jogging 4th axis?

« on: September 10, 2006, 07:28:06 PM »

I just added the fourth axis (rotary table) to my system and can't seem to find out how to jog it. I am using the a drive output for the rotary out put.
                                 Thanks for your time!   -G-

2

General Mach Discussion / 3d on radius

« on: August 04, 2006, 12:14:43 AM »

Looking for software to use with mach3 mill to engrave photo images on radiused surfaces.
            Any help will be appreciated!    -G-

3

General Mach Discussion / Photo to engraving?

« on: July 12, 2006, 04:15:21 PM »

How do I go from a photo to a code I can run?
                           Thanks in adv. for your time.    -G-

4

General Mach Discussion / mach2 but not mach3?

« on: April 07, 2006, 10:51:03 AM »

  I am involved in converting my mill to cnc and am having some problems with the software.
Currently using demo versions to test outputs and breakout board. I was able to get full function using parallel port output with mach2 however when I try to setup mach3 in the same manner I cannot get any output to port. All settings for ports and pins are the same any ideas on what I am missing?I am interested in testing features of mach3 before buying.
  Running xp pro on a hp pavilion.                          
                                                                        Thanks for your time!  -G-