Guest
Show Posts
1
General Mach Discussion / STEPCRAFT Plugin
« on: September 18, 2019, 03:55:17 PM »
Hi evryone,
I have a stepcraft 420 router with diffrent application (printer extruder, milling, touchprobe and laser)
I am using UC100 controler and Mach3 as software but unfortunatly I did not find andy pligins for these application! I know that there are (Stone.. from UK has -they are selling Mach3 with UC100 and stepcraft) but unfortunatly only in UK.)
How can I have this pligin to use stepcraft at fully potential!
Thank you
I have a stepcraft 420 router with diffrent application (printer extruder, milling, touchprobe and laser)
I am using UC100 controler and Mach3 as software but unfortunatly I did not find andy pligins for these application! I know that there are (Stone.. from UK has -they are selling Mach3 with UC100 and stepcraft) but unfortunatly only in UK.)
How can I have this pligin to use stepcraft at fully potential!
Thank you