Guest
Show Posts
1
Mach4 General Discussion / Input/Output PIN Mapping not being saved
« on: September 07, 2019, 08:07:43 AM »
Hi,
We have Mach4 running with a UC300-ETH motion controller and every time I restart the Mach4 application I have to setup the Port/PIN mapping again as it does not get saved. Any ideas where to look to resolve the issue as it is driving me mad!
Thanks
Adam
We have Mach4 running with a UC300-ETH motion controller and every time I restart the Mach4 application I have to setup the Port/PIN mapping again as it does not get saved. Any ideas where to look to resolve the issue as it is driving me mad!
Thanks
Adam