Guest
Show Posts
1
General Mach Discussion / How to get the lead of the ballscrews on the mill configurated in Mach 3??
« on: April 06, 2006, 03:50:12 PM »
Hi
Me and a friend managed to get one of the mills started today. We couldn´t get the right configuration in the Mach 3 software though.
Is it under copnfiguratio --> motortuning that it should be done. "Steps per" Is it per revolution or per what? Couldn´t find anything about this in the Mach 3 helpfile.
The mill has steppers with 1,8 degrees steps which gives 100 steps per revolution and the lead on the ballscrews is 4 mm.
Are having the same problem for a servodriven router that I´m building. How should I do it?
Best regards / Anders Molin
Me and a friend managed to get one of the mills started today. We couldn´t get the right configuration in the Mach 3 software though.
Is it under copnfiguratio --> motortuning that it should be done. "Steps per" Is it per revolution or per what? Couldn´t find anything about this in the Mach 3 helpfile.
The mill has steppers with 1,8 degrees steps which gives 100 steps per revolution and the lead on the ballscrews is 4 mm.
Are having the same problem for a servodriven router that I´m building. How should I do it?
Best regards / Anders Molin