Hello Guest it is March 29, 2024, 02:48:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - nigata

Pages: 1
1
Hello everybody.

I am quite new to the CNC world and i have a problem with my setup on my plasma machine.

I use a chinese RnR motion usb Card with Mach3



I had managed to setup motors and all,

the problem i have is that i cant manage to get the torch to open. I use a simple relay. I had setup the output but nothing changes and the card doesn't give any indication it gives any signal.

in the diagnostics output1 has a red led when i turn on it manualy

I dont use a THC.

any suggestions?

Pages: 1