Hello Guest it is March 29, 2024, 01:39:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ChuckAustralia

Pages: 1
1
General Mach Discussion / Machining relief problems
« on: July 26, 2019, 04:08:42 AM »
Hi guys,

I'm trying to machine a relief designed with Fusion 360 derived from a jpeg, what I'm finding is the tool continually goes deeper into the job, where it should be carving at a maximum of 3mm its cutting down to more like 17mm and not much of a profile to be seen.

I'm using a small Chinese cnc machine and I don't have any trouble engraving shapes and text.

I recently bought a mach1 license hoping that would make a difference but that only allowed more lines to be processed.

I don't know if its the CNC or mach3 settings at fault

I have attached what I think is the config xml, the Confcheck text and the item .tap file

Thanks for looking at this for me
Regards Chuck   

Pages: 1