Topics

1

General Mach Discussion / Upgrades, what a pain in...

« on: October 12, 2007, 07:51:39 AM »

It really makes me go crazy that EVERY time I upgrade my Mach3, R2.48 now, the highlyght of the worked path in the toolpaths disappears and it is impossible to judge how far the tool has come.

My toolpaths settings are:  Enhance=   1     1    0       Material=     0       0.1        0.1

as usual now I have to write everything down and remove/reinstall Mach3. What a chore!

2

General Mach Discussion / Inductive proximity switch

« on: June 28, 2007, 03:50:58 AM »

I have bought one on ebay, the idea is to test it as homing switch or tool lenght gauge. I see that operating voltage is 10-30V and the output will be the same minus a  drop of 1-2V.  So I'm looking for a diagram showing how to interface it to the home's pin or the input pin of the parallel port of the pc.
Any help will be much appreciated. Thank you.

Gianni

3

General Mach Discussion / Hidden toolpath

« on: March 10, 2007, 02:40:09 PM »

I made a new profile of my own and I cannot see the worked toolpath in it. Config/Toolpath settings are the same than in the default profile, which is working fine. Any hints? Thank you.

Also the iconized tool is pretty big and not that transparent hiding a lot, are there more shapes to chose ?

Gianni

4

LazyCam (Beta) / LCAM V.2.66 download

« on: December 04, 2006, 10:13:13 AM »

Where can I download this from ? I was running Mach3 1.90 and to get a newer Lcam I upgraded to 2.0.020, but the Lcam I got is V2.0

Tried the FTP but does not accept my mail address as password.

regards,
Gianni