1
General Mach Discussion / Plasma ignition and stop lag problem
« on: July 05, 2019, 04:26:52 PM »
Hello, I come to you because I have a problem and I think it's problably due to my Mach3 configuration. When I start a plasma cutting, the plasma start and stay a moment at the same place before cutting, and it stop before the end of the cutting. I have already set my 4 parameters for Dwell in "Spindle setup" at 0, but nothing change. I think my GCODE is ok, but I let you invoice, just in case.
Thank you !
Thank you !