1
General Mach Discussion / Linear cutting guidance
« on: June 27, 2019, 12:47:30 PM »
Hello all. So i use Mach3 to run a linear cutting saw. I make sequential cuts of a specified thickness any number of times. Occasionally, i have to make a sequence of cuts at a different thickness immediately after i finish the first set. I have a loop that can generate the GCode for the set of sequential cuts. I'm at a loss however as to how i can use the last X coordinate entered into the GCode list and use that as the start to add the new set of sequential cuts. I realize i could add all of the cuts manually but i would rather i set up the screen to make the computer do it for me.
Any thoughts or ideas would be appreciated.
Peter
Any thoughts or ideas would be appreciated.
Peter