Hello Guest it is March 28, 2024, 09:34:30 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - batteryfactory

Pages: 1
1
General Mach Discussion / Mach 3 and Price CNC
« on: December 24, 2019, 09:05:46 PM »
Hello,
trying to upgrade my table with a THC got a Price CNC AVHC10. I'm running Sheetcam, Mach 3, Gecko G540 REV 4. Got the THC wired in having issues with the inputs.
when I run the signal test  "UP" Torch up lights up, "Arc_Ok" Torch On lights up, "Down" Torch on and Torch up light up. I have double checked wiring and have ports and pins set how the manual says. Not sure what I'm missing on this one.

2
LazyCam (Beta) / Having issues loading GCode
« on: May 21, 2019, 09:09:33 AM »
Hello,
I'm new to all this. Built a 5x10 plasma table in my shop this month. did first test cuts last weekend. After the test cuts I purchased the license for both Lazycam and Mach 3. I'm running windows 10 on my PC. Ran fine for a handful of cuts. Tried making some adjustments to clean up the cuts. When I upload the new GCode into Mach 3 I get a "Bad Character" error message pointing at N30.
"N30 {SPINDLE}(PLasma On).
The Gcode that worked was
 N30 was G28.1 (Probe for Stock).

Pages: 1